Choose The Right Finish


4Lacquer

The top layer is spray coated with five primer coats and at least two top coats of Treffert aluminium oxide lacquer which is UV cured. The finish can range from matt to gloss. The result is a smooth hard wearing and low maintenance surface which enhances the natural grain and beauty of the wood.

Care: Avoid scratches by minimizing surface dust and grit. Install matting and sweep/ vacuum regularly. Furniture should be protected with felt pads.

Note: A spray lacquer cleaner is recommended to avoid using too much water.

See Maintenance advice


5Natural Oil

Up to four coats of natural WOCA oil are applied by rollers, each coat is buffed into the top layer permeating the grain and adding a matt sheen to the surface which is then left to cure. This finish is the most natural of any, creating a deep lustre whilst maintaining a tactile surface.

Care: Keep the surface free from dust and grit and protect furniture with pads. Clean and condition the floor with natural oil soap to prolong its life between re-oiling.

Note: Natural oiled floors can benefit from a coat of maintenance oil on installation and should be maintained in the same way periodically.

See Maintenance advice


6UV Oil

Up to four coats of natural WOCA oil are applied by rollers and buffed into the top layer permeating the grain. Each coat is cured under ultra-violet light creating a slight satin sheen on the surface. This finish combines the natural lustre of the oil with a tougher surface finish.

Care: Keep the surface free from dust and grit and protect furniture with pads. Clean and condition the floor with natural oil soap to prolong its life between re-oiling.

Note: UV oiled floors will not need a coat of oil on installation but should be treated with maintenance oil periodically depending on usage.

See Maintenance advice

Call the team on +44(0)1276 488099